Date: Tue, 03 Aug 1999 20:50:45 -0400 From: "J. Pires" <worldnet.piresnopsamdnet.att.net> Subject: Re: 900 Airflow/Sideshields
On my 86 900T when I removed the moldings on the door, the "square "holes were already there. Normally to the rear of the rear tires, and front of the front tires the holes are there to hold the moldings. I think the Turbos are pre drilled, I checked some non Turbos and they did not have the holes. The holes are covered inside the door by somr type of tape, you have to pull part of the molding to check for the holes. SAAB wants $1.00 each for the plastic grommets that go in the holes to take the sheet metal screws that hold the rails, I went to PEP BOYS and at $1.29 for a box of 5 did the same job. Good Luck Joe RCS wrote: > Hi to all! > Has anyone bought the airflow kit, especially the door panels ("side > shields") for the old "classical" 900? There was a set available as an > option.... > The set is not available any more and IŽd like to install a used one > (MY87-94) but I got no installation procedure (where to drill the holes > into the door....). > Has anyone the procedure and can mail/fax it to me or can tell me where > to get this? > > Thanx so far > RCS
 |
 |
 |
 |
 |
