Date: Wed, 19 Mar 2003 18:19:19 GMT From: Paul Halliday <pjghnopsamyonder.co.uk> Subject: Re: Classic 900 Dash Replacement
in article b59dgg$26f33g$1nopsam52899.news.dfncis.de, Grunff at grunffnopsam.com wrote on 19/03/2003 09:31: > Paul Halliday wrote: > >> Have I just not made a good enough seal when re-fitting the metal ring, or >> did other models have an open connector in number 7? The vac pipe cluster >> seemed to go on with less resistance than it came off the original. Looks >> like I'll have to remove the dash again and retro-fit the vent control. >> Grrrr. > > Hmmm...I really can't remember. I'm not too tempted to remove > one of my dashes to check either ;-) > > I'd pull it out again and check the seal. I'll have a look in my > Bentley when I get home, see if there's a photo/diagram of the > back of the vac switch. > > >> Also, only the top two (of three) and bottom two (of three) electrical >> connections on this controller were connected. Is this normal? > > Yup, that's normal. Cheers for that Grunff. I think it's going to be a "pull off and have a look job", unfortunately. I had another go at re-seating the vac cluster today, but still no good :( Paul
 |
 |
 |
 |
 |
