Date: Mon, 5 Jul 2004 16:59:26 -0400 From: "waycoolstuff!" <jarrodnospamulink.com> Subject: Re: HELP heater core WOE continues
Aha, alternator very loose causing vibration right against the underside of the rubber hose. Eventually this caused a split on the underside of the hose so I replaced the hose (the one from the water pump) and bit the bullet. I think its working. (fingers crossed tightly) The lesson here: things aren't always as they seem so take everything apart which might be the cause and inspect visually outside of the engine compartment. "waycoolstuff!" <jarrodnospamulink.com> wrote in message news:10eiulv6palag9dnospam.supernews.com... > Damn, replaced the heater core and then.....heater working, blower working, > hot and cold air but the rubber hose (connected to bottom of core at > firewall) split and sprayed coolant everywhere. Took a deep breath, babied > the car home and cut the split out of the hose and inserted a male to male > connector. Cleaned the coolant and ran the car. The hose split again ! this > time at the other end of the hose near the engine block and now there seems > to be evidence behind the drivers seat that coolant is continuing to pool up > inside the car. Can anyone help me figure out this mess? > 91 900 S with A/C > >