Date: Thu, 23 Sep 2004 10:39:43 +1200 From: Richard Sutherland-Smith <richard.ssnospamr.net.nz> Subject: Re: 99/c900 Clutch Spacer Tool?
In message <cis7qj$i79$1nospama.suomi.net> "A Peltola" <akzu900nospamail.com> wrote: > In my case, there were two bolts under the flywheel connecting the block and > transmission. So I had to remove the clutch and the flywheel to get to these > bolts.. > > -Aki & c900t16 > Oh yes, I remember those. I am not sure if they are meant to be done up, or whether they are left over from the Triumph ancestry; the last time I didn't use them. Haynes removes the engine from the box with the clutch in place so they don't expect them to be there, but they do use lots of sealing compound across there instead so that's wht I did. My main problem was putting the oil-seal that goes round the clutch shaft in the wrong way and getting oil leaks until I thought about which way the oil was "pushing". It seems ok now. -- Richard Sutherland-Smith 19 Webb Road, Wanganui 5001, New Zealand
 |
 |
 |
 |
 |
