Date: Sat, 30 Apr 2005 19:29:24 GMT From: "Dexter J" <lamealameadingdongnospamlamelame.org> Subject: 9000 Loom uprate - ideas and comments?
Salutations: I think I am about to start pulling my loom and relays to check them over for fit, finish , conductivity and function. Anyone have a really good source for a complete schematic for a 1993 9000 Aero? I would very much like to do this once if possible. While there, I would like to install better connectors and heavier wire where appropriate. Any leads on a good general source for both? Finally - there are several loom end point connectors that are specific to a given electrical device. ie the Safety Valve. Any thoughts on casting better (more robust and perhaps water proof) connectors in these cases? Is it time to break out my old Lionel epoxy modeling kit? Cheers - I'll kick this over to saabnet as well to see if it picks up traffic too -- Radio Free Dexterdyne Top Tune o'be-do-da-day Patio Lanterns - Kim Mitchell http://www.dexterdyne.org/888/081.RAM all tunes - no cookies no subscription no weather no ads no news no phone in no sign up required - all the Time