Mark - -
I think I read your post right, and that it describes blowing the back of the slave open before the slave was bolted down to the tranny.
You need to put all three bolts in and tighten all three right down before bleeding the system or expecting the slave to press the pressure plate fingers down and release the special ring tool.
Otherwise the pressure takes the path of least resistance, which is to press the slave apart instead of pushing the slave piston and throwout bearing against the pressure plate fingers.
Simple careful clean reassembly will fix the slave if you've done this, no new seals needed, then put your stack back in, install the three bolts and continue with the bleeding process.
posted by 71.173.9...
Posts in this Thread:
Members can receive an alert when someone posts in this thread.
Post a Followup
The content on this site may not be republished without permission. Copyright © 1988-2012 - The Saab Network - saabnet.com.
This is a moderated bulletin board - Posting is a privilege, not a right.
Unsolicited commercial postings are not allowed (no Spam). Please, no For Sale or Wanted postings, SERIOUSLY.
Classifieds are to be listed in The Saab Network Classifieds pages.
This is a problem solving forum for over 250,000 Saab owners, so expect to see
problems discussed here even though our cars are generally very reliable. This is not an anything goes
type of forum. Saabnet.com has been a moderated forum since 1988. For usage guidelines, see the
Saabnet.com Mission and Purpose Page. Please remember that you are
not anonymous. Site Donations
Your address is: 220.127.116.11 - Using CCBot/2.0 - Logged.
Site Members do not see red text instructions, green links, and bottom of the page banners.
Click here to see all
the Site Membership Benefits!