1979-1993 & 94 Conv [Subscribe to Daily Digest] |
[Main C900 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: Replace motor mounts with engine in Posted by Landjet [Email] (#16) [Profile/Gallery] (more from Landjet) on Sat, 31 Dec 2016 21:38:21 In Reply to: Re: Replace motor mounts with engine in, ahanson [Profile/Gallery] , Sat, 31 Dec 2016 14:21:30 Members do not see ads below this line. - Help Keep This Site Online - Signup |
I did this job, it was helpful to have an open end 12 or 13 mm that was very thin. Take the engine mount off the block if you can, then cut with a hacksaw a slot so you can put one of the bolts into the engine, then slide the bracket on through the slot.
I can't recall which bolt location it is, but as I recall it became clear once the bracket was of, as it was a super tough installation if the slot wasn't there.
I did this around 10 years ago, and posted something, goes back to far to remember.....
I have to do this on the 89 winter beater, I think I'll take the intake manifold off, so I can install a new gasket, and maybe a new radiator hose under there as well. In other words, take more apart than you need to, making the job easier and target other repairs along the way. Like the dreaded oil cooler lines........
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.