1985-1998 [Subscribe to Daily Digest] |
Hey guys, I'm trying to calibrate the ETS system on my 93 9000 aero.
About a month ago the TCS CTRL light came on, but never caused any issues, then one day I started up the car after a short drive and it was in LHM.
Plugged in the tech 2 and found 4 error codes.
675B0-Permanent
"ETS ECU Fault: Calibration Not Completed"
44261-Permanent
"Speedometer Signal Absent"
24260-Intermittent
"Speed Signal From TC/ABS Absent"
42220-Permanent
"No Voltage To Terminal No. 22 &/Or No. 13"
I cleared all the DTCs, and attempted to calibrate the ETS system in this manner.
Diagnostics>Engine>ETS>Read Values/Activate>Activate
I first select 971 'BASELINE SETTING" and it says 'STARTED', then maybe a 2 or 3 seconds later it says 'FINISHED'.
(on subsequent tries, the tech2 would hang at "started")
I proceed to 973 'CALIBRATION warm up' or something of the sort, but all it has is a selection box for on/off and a bar at the top that becomes solid when I select 'On'. I then start the car, it stumbles turing the first few revs but then goes up to normal idle speed, ~850rpm.
But the TCS CTRL light is still on and I have no sweeping RPM range as described in other calibration procedures I've read online. I key off and out, wait a second or two, and start the process over again.
While the TCS CTRL light is still on, I only have one reoccurring DTC, the
675B0-Permanent, "ETS ECU Fault: Calibration Not Completed" code.
I've gone through the last 3 parts about 4 times with no change.
I'm clearly out of limp home mode, but the ETS system has a problem calibrating. I'm I doing something incorrectly? A different procedure perhaps? if its worth noting, I'm using version 44 of the tech2 software. and low on gas if that matters(in the reserve)
Thanks for your help!!
posted by 146.115.14...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.