Step 1
Open the hatch and remove the cover over the light. It's held on with plastic clips, gently pull it towards you and it pops right off. Last modified: Oct 29, 2010 |
Step 2
Gather your tools, 10mm wrench/socket/nut driver, small flat screwdriver, and a beer. Remove the 3 nuts holding the light in and disconect the wireing. Mine was wrapped in tape. Last modified: Oct 29, 2010 |
Step 3
Close the hatch and lift out the light. Last modified: Oct 29, 2010 |
Step 4
Remove the 3 screws (philips) holding the black cover on the LED strip, and then replace it after dropping in the new strip. It only fits on one way, keep in mind everything is plastic so don't over tighten. Last modified: Oct 29, 2010 |