![]() |
2003-2011 [Subscribe to Daily Digest] |
![]() | [Main 93 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
New Clutch, parts questions Posted by Sondeen [Email] ![]() ![]() |
It getting to be time for a new clutch in our 2006 9-3 SC. Last October it began to show signs of slipping in 5th gear under very high boost / acceleration. About 14k later, slipping is starting to become more frequent, and in third and forth gear now and then.
Based on prior discussions on Saabnet, for parts I am planning to order:
clutch disk & pressure plate,
flywheel,
master cylinder,
slave cylinder,
the hard hydraulic line to the slave,
the flexible hydraulic line to the master cylinder,
engine rear main seal.
I have a few questions about possible additional parts.
Should new flywheel bolts be used? Or is it ok to re-use the old bolts?
Is there a transmission input shaft seal that should be replaced? I can't find a PN for it listed by any suppliers.
Are there any other seals or parts that are recommended for replacing? For example, I see Eeuro lists a Disconnection Valve 55563644, and a Clutch Tube Retaining Sleeve 90522038 which I suppose are for the hydraulic lines?
Thanks
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |