1979-1993 & 94 Conv [Subscribe to Daily Digest] |
 | [Main C900 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: Sensor location? Posted by RS [Email]  (#15)  [Profile/Gallery]
(more from RS) on Wed, 5 Mar 2003 13:29:32
In Reply to: Sensor location?, Greg Netzner, Wed, 5 Mar 2003 12:57:32 Members do not see ads below this line. - Help Keep This Site Online - Signup |
The sensor is located between the harmonic balancer and the oil pump housing. Not an easy place to get at.
You'll find the pigtail connecting it to the wiring harness with a 3-wire connector on the driver's side of the block, under the intake manifold.
Other than wiggling the wires leading to the sensor with the engine running and seeing if it cuts out when you do that, I don't think that there's much of a diagnosis regimen - especially with an intermittent problem like that.
You can get Used ECUs a lot cheaper than that, but I doubt that the ECU is the cause of the engine dropping out like that.
Take a look at Townsend Imports page on LH 2.4 No-start Checks. It may give you some insight and some diagnostic techniques. But it's really meant for the situation in which you can't start the car. About the only other thing that comes to mind is swapping out the ignition module with a known good one to see if the cutting out recurs.
posted by 66.21.16...
http://216.78.172.244/engine_folder/nostart24.htm
, Wed, 5 Mar 2003 11:53:55, Wed, 5 Mar 2003 13:29:32 <-- Viewing This Message
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
 |
 |
 |
 |
 |
