1979-1993 & 94 Conv [Subscribe to Daily Digest] |
![]() | [Main C900 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
Re: help!! - stripped threads on motor mount bracket Posted by Roger D [Email] ![]() ![]() In Reply to: Re: help!! - stripped threads on motor mount bracket, matt, Sat, 9 Jun 2007 15:35:48 Members do not see ads below this line. - Help Keep This Site Online - Signup |
Not a job I've done. I stripped an exhaust stud hole in my head. The next size larger tap in my tool box is a 3/8ths. I tapped the head and installed a 3/8ths stud. The hole in the cast iron manifold is just large enough to allow 3/8ths bolt pass. I just checked my spare engine in the garage. The hole thru my 92 na block is a little smaller than my 3/8ths tap. I couldn't fit my 3/8ths 90 degree air drill in that tight space to drill out the block hole. A small 90 degree air cut off/grinder might get in there to enlarge the hole.
posted by 24.10...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |