1979-1993 & 94 Conv [Subscribe to Daily Digest] |
![]() | [Main C900 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
well, you should treat air leaks in a methodical manner Posted by nicknick [Email] ![]() ![]() In Reply to: Re: fuel distributer??? try hose leaks/splits, and dist, Andreas, Thu, 19 Jul 2007 03:45:54 Members do not see ads below this line. - Help Keep This Site Online - Signup |
, don't assume they don't leak because you can't hear hissing. actually, you should replace every vac hose, one by one, then go through turbo plumbing from amm to throttle body, remove and inspect each one (clean as you go). check the hose on the elcd system in the drivers fender, hiding behind the corner signal light (also make sure the plug is on this canister, look down by apc box). also, and this caused me problems once, check the breather hose that runs from cam cover forwards to inlet hose between amm and turbo. there is a 'y' half way down this hose that can split, and be difficult to see. when you said you checked the ntc, how did you do it? it has a resistance that decreases with temp increase (NTC), to a point of about 300 ohms at around 175f. you need to check when hot to be sure. also check that every little vac module holds vac-just suck on one end of hose attached to distributer module, etc, and check that it doesn't fall off your tongue. good luck
posted by 208.54.1...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |