![]() |
[Subscribe to Daily Digest] |
![]() | [Main Performance Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
it will hit 100% no problem Posted by jak [Email] ![]() ![]() In Reply to: Re: Injector duty cycle for JAK's c900 chip?, Hans, Sat, 10 Jun 2006 21:34:39 Members do not see ads below this line. - Help Keep This Site Online - Signup |
the stock chip will just do it verry erly like at 3200RPM at 5V on the AMM
this made it nesessary to have a nasty rich spot at that point in order to prevent leanout higher in the RPMs
with my S1 100% will happen mabey 1000RPM later
if I tried to keep DC% down below 90% your car would run crazy lean with those injectors as they are verry small
so the larger the flow capacity of the injector the lower I can make the DC% to achieve the same AF ratio
I was never realy concerned with when it hit 100% just so long as the AF stayed fairly level
I noticed on the revised stage2 chip for the 431 injectors that it happened at about 5500RPM & I could tell because that was the rich spot (about 10.8:1 & then it tapered leaner up to 7000RPM to like 11.5:1 if I remember corectly.
this happened with the values at those adresses higher then the spot at full load 5500RPM being higher so I knew I couldent turn them on any more
I now have a chip which runs 42lb hour injectors on 2.2 LH :-) so this one may not hit 100% or if it does it dosent till like 6500RPM
blah blah blah :-)
hope that helps
take care
JAK
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |