Date: Thu, 17 Jun 1999 21:56:18 +1200 From: Wanganui Collegiate NZ <richardDOTssnopsamr.netSTOPnz> Subject: Re: APC GAUGE
In article <7k6et4$fuf$1nopsam7.svr.pol.co.uk>, DAVE LEE RALPHSON <URL:mailto:davenopsam.freeserve.co.uk> wrote: > hi gang > can anyone tell me how far the needle on the turbo boost gauge should go. > mine will only go just past the half way or just past the middle of the > yellow section even with my foot to the floor. as I only have had the car 3 > months I don't know what is the norm > car is a 91 9000se auto > > thanks people > Dave Before you rush off spending lots as suggested by some, find the dump valve in a tube between the lower air-intake and the throttle. Disconnect the small vacuum tube so it is left on the valve and suck on it; it should hold a vucuum, if not replace it. My 87 9000T was doing what yours does and replacing this put it up to the red and back into the white on overrun. -- Richard Sutherland-Smith Wanganui Collegiate School, New Zealand http://www.collegiate.school.nz/ Acorn 200MHz Risc PC