Date: Mon, 24 Jun 2002 13:52:06 GMT From: "notooyou" <peacenopsame.net> Subject: Re: Keyless entry remote programming?
I had just recently purchased the car and it came with two keychain remotes that I assume will unlock and lock vehicle and set / unset the alarm. I am not looking for anything tricky to do, just make them work again. I believe that they have just come unprogrammed. I have a LandRover Discovery and they can unprogram over time due to battery disconection... I was hoping there was a procedure to reprogram them.. Thanks again. The remotes are black with a sigle light gray button with SAAB Anti-Theft System written to the site of the single button. And a red light that comes on when the button is pushed. Thnaks again, Kyle "KeithG" <noonenopsamspring.com> wrote in message news:3D1721A4.1030601nopsamspring.com... > Saw your other post, and you have a CV. The change in the program > requires removing the back seat bottom, lifting the alarm unit up and > flipping a couple of switches. What do you want to program it to do? > > KeithG > > KeithG wrote: > > A bit more information is required. Is this a 'SaabGuard' alarm? If so, > > the remotes will say 'Saab' on them and they will be black with a single > > white button. Is the car a convertible? I will assume that it was a > > Saabguard alarm which was installed by the dealer in a 3 dr or 4 dr. I > > have one of these in my '92. The Saab installation gives you an alarm > > which can be turned on by the remote or by locking the driver door > > (passive arming). The actual alarm unit is capable of 'keyless entry' > > and also 'light flash', but these were not wired up at the time of > > installation. It can be done, but it depends on your level of expertise. > > I was able to do it to mine. You must 1) get a door lock motor for the > > driver's door 2) wire it up to the lock ECU 3) wire the lock ECU to the > > alarm unit to the appropriate pins (this information is detailed in the > > Bentley manual for the up to '93 convertibles which used this alarm unit > > and had keyless entry from the factory). Light flash requires a DPDT > > relay wired to the alarm unit to the appropriate pin (again in the > > Bentley) and wiring to the turn signal circuit. > > > > Good luck, > > > > KeithG > > > > notooyou wrote: > > > >> Anyone know how to reprogram a keyless entry remote on an older 900? > >> I have > >> 1992 and I would like to program the keyless remotes to work? any Ideas? > >> Thanks in advance, Kyle > >> > >> > > >
