Date: Tue, 13 May 2003 09:38:39 +0200 From: "Rob Bloemendaal" <rob.bloemendaalnopsamapps.com> Subject: Re: How to remove the pulley from the power steering pump?
A few weeks ago I went to a car dismantler (specialized in Saab and Volvo) to get a powersteeringpump for my 900S (1996). When I came back to my car I saw that the pump was the good size but the pully was to big. It was a powersteeringpump of a Saab 9000. I couldn't get the pully of because it is not only screwed to the pump but also pressured (I don't know the correct words) to the pump. My advise to you is to get a complete pump (incl. pully). When you try to change the pully it can dammage and it won't be as strong as the original one. I went back to the dismantler and got a complete pump for the 900 and the problem was over. Best regards, Rob "Mario Lachance" <mario.lachancenopsamatico.ca> wrote in message news:LyAva.329$I83.100256nopsam20.bellglobal.com... > Hi, > > I have to replace the power steering pump on my saab 9000 CD 1992. But I > don't know how to proceed to remove the pulley from the pump. Does anyone > know how to do this on this car? > > ALLDATA only mention the following: > Use tool 89 96 423, or equivalent, to remove the pulley from the pump shaft. > Use tool 89 96 415, or equivalent, to fit the pulley on the pump axle. The > pulley should be fitted so that the pump shaft and pulley hub sit edge to > edge. > IMPORTANT: The pump shaft should not be tensioned when tightening or > releasing the pulley. Test drive and check operation. Inspect for any > possible link > > Anybody know how these tools (89 96 423 & 89 96 415 ) look? > > Thank you > Mario > >
 |
 |
 |
 |
 |
