1994-2002 [Subscribe to Daily Digest] |
![]() | [Main NG900 & OG93 Bulletin Board | BBFAQ |
Prev by Date | Next by Date | Post Followup ]
Member Login / Signup - Members see fewer ads. - Latest Member Gallery Photos
holding gaskets Posted by MJM [Email] ![]() ![]() In Reply to: Re: Torx sizes to replace valve cover gaskets on B234 motor, AllanJ, Tue, 27 Apr 2004 15:04:22 Members do not see ads below this line. - Help Keep This Site Online - Signup |
The rtv will do a great job of holding the gasket in place as you fit the cover, but it'll squeeze out when you torque the cover down and the little 'worms' that squeeze out on the inside have lots of potential for getting in places they shouldn't. I posted on this about a week ago, there were good follow ups as well. I used a few sandwich-baggie twist-ties to hold the gasket in place until I got the cover down and aligned, someone else reported using spray adhesive, yet another person had good luck with a grease. The trick is to not leave anything inside the engine.
I found eEuro's price to be the best, by far.
regards, Mike
'95 SET
112k
posted by 141.158.219...
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
![]() |
![]() |
![]() |
![]() |
![]() |