 |
|
|
[Subscribe to Daily Digest] |
[Profile/Gallery]
, Mon, 2 May 2005 12:59:57
Members do not see ads below this line. - Help Keep This Site Online - Signup
Salutations:
I actually read through your original post on that one here a while ago (thanks, really useful post).
In my case I'm seeing the boost run up to just below the yellow/red slotted area on the boost gauge. Not base boost - but not full boost either. So I think you may be on the right line given that is where I think the boost should cut out on cruise. Don't hesitate to correct me if I'm wrong - should it cut out back to 50% (like limp mode) on cruise?
Anyway - I have been told here that on my Aero model - the gauge should be just into the full red before it flattens off - if this is correct, then in total it is reporting about 22% short on boost - which is about right for the missing 75hp I think.
I haven't been doing much about since (and until) we figured out why it was springing a pile of erroneous CEL's for at least the past 4 years (one year with me) - just to make sure we have in fact fixed it. So far so good - but no stunning increase in boost as yet.
http://www.saabnet.com/tsn/bb/9000/index.html?bID=207285
I'll check the resistances on the BPC this month and was planning to go over the cruise system from the steering stock out.
Personally - I think that somewhere in the two owner bug hunt for the CEL problem someone may have adjusted something back. Or - crossed something when they installed the TCS cut out switch. Or - not properly calibrated the throttle body (which was replaced by the PO, to no avail).. Or even perhaps all of the above..
Hey - you wouldn't know of a good link for a schematic and test procedure for the 1993 loom anywhere would you?
Dexter J
posted by 24.222....
, Mon, 2 May 2005 12:59:57, Wed, 4 May 2005 10:12:57
, Sat, 30 Apr 2005 20:32:54
No Site Registration is Required to Post - Site Membership is optional (Member Features List), but helps to keep the site online
for all Saabers. If the site helps you, please consider helping the site by becoming a member.
 |
 |
 |
 |
 |
